Tecumseh engine that has a fairly obvious problem with the case... and generator endplates

View after repair of windings

Note outboard bearing housing on front in this picture.

Generator on its new mounting frame with a B&S 5 horsepower Quantum engine.

View showing generator slider for belt adjust.

Bolt used to adjust tension on the drive belt by pulling generator slide away from the engine.

Finished product. Note that I finally found a use for that empty freon tank! It was a tank that held 30 lbs of R-134A. Now it holds about 3.6 gallons of gasoline, giving me at least 12 hours of run time.

Once again, a hardy thanks to NJ8V for helping machine a pulley assembly and the drive shaft of the generator for the cause!

Generator fever; it is a terrible thing.

Oct 12, 1999